Wacker Neuson CRT 48-31V Manual del operador descargar pdf (Pagina 42)

Maintenance CRT 36-24A/25

42 wc_tx000640gb.fm

4.14 Troubleshooting

Problem Reason Remedy

Engine does not start. Engine problem. Consult engine manufac-

turer’s service manual.

Machine out of balance;

wobbling excessively.

Operator is over-steering. The movement of each

gearbox is controlled by

“stops” to provide the cor-

rect relationship of the con-

trol arm movement to

machine movement.

Excessive pressure on con-

trol arms in any direction

will not increase reaction

time and can damage

steering controls causing

machine to wobble.

Trowel arm(s) bent. Replace trowel arm(s).

Trowel blade(s) bent. Replace trowel blade(s).

Main shaft(s) bent due to

machine being dropped.

Replace main shafts(s).

Poor handling; excessive

range in control lever

movement.

Worn bushings due to lack

of lubrication.

Replace bushings and

lubricate at least every 20

hours.

Control arm lever adjust-

ment has moved or control

arm has been bent.

Reset control arm lever.

Lower control arm(s) bent.

This can be caused by

dropping machine.

Replace lower control

arm(s). Use lifting brackets

and/or forklift pockets pro-

vided on machine for lifting.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

Comentarios a estos manuales

Sin comentarios

Wacker Neuson CRT 48-31V Manual del operador Pagina 42

Comentarios a estos manuales

Relacionado con productos y manuales para No Wacker Neuson CRT 48-31V