Wacker Neuson CRT 48-31V Manual del operador descargar pdf (Pagina 40)

Maintenance CRT 36-24A/25

40 wc_tx000640gb.fm

4.12 Engine Oil and Filter

See Graphic: wc_gr000155

Drain oil while engine is still warm.

4.12.1 Remove oil fill cap (a) and drain plug (b) to drain oil.

Note: In the interests of environmental protection, place a plastic sheet

and a container under the machine to collect any liquid which drains

off. Dispose of this liquid in accordance with environmental protection

legislation.

4.12.2 Install drain plug and tighten.

4.12.3 Fill engine crankcase with recommended oil to the upper limit mark on

the dipstick (c).

4.12.4 Install oil fill cap and dipstick securely.

4.12.5 Remove front pedestal panel to access oil filter. To replace the oil filter,

remove the installed oil filter after oil has been drained. Apply a thin

coat of oil to the rubber gasket of the replacement oil filter. Screw the

filter on until it just contacts the filter adapter, then turn it an additional

22.24 mm (7/8 in.) turn. Refill with oil as described above.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 57 58

Sin comentarios

Wacker Neuson CRT 48-31V Manual del operador Pagina 40