Wacker Neuson CRT 48-31V Manual del operador descargar pdf (Pagina 26)

Operation CRT 36

26 wc_tx000639gb.fm

3.6 Starting

Before starting the operator must know the location and function of all

controls.

3.6.1 Push down on the throttle foot pedal, turn the engine keyswitch (o),

and hold it until the engine starts.

Note: If the engine is cold, pull out the choke control knob fully. The

choke may need to be opened even when starting a warm engine.

NOTICE: Cranking the engine for more than 5 seconds can cause

starter damage. If the engine fails to start, release the keyswitch and

wait 10 seconds before operating the starter again.

Note: The engine has an oil alert light to notify operator if the oil

pressure is low. If engine will not start, or stops during operation, check

engine oil level.

3.6.2 Allow the engine to warm up before operating the trowel.

3.7 Stopping

To stop trowel movement, return control levers to their neutral position

and release pressure on the throttle foot pedal.

To stop the engine, turn the keyswitch to “O” (off).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

Sin comentarios

Wacker Neuson CRT 48-31V Manual del operador Pagina 26