Wacker Neuson Cub 200 Manual del operador descargar pdf (Pagina 32)

Maintenance Cub 200/300/300 HD

wcghi_tx000721gb.fm 32

4.5 Inspecting and Aligning the Burner Electrodes

See graphic: wcghi_gr004020

To inspect and align the burner electrodes, carry out the following

procedure.

Inspection:

4.5.1 Remove the burner assembly. See section Removing and Installing

the Burner Assembly.

4.5.2 Inspect the electrodes for the following:

• Wear. Be sure to inspect the ends of the electrodes for

pitting. Replace any worn electrodes. See section

“Replacement or Alignment”.

• Straightness. Replace any bent or broken electrodes.

See section “Replacement or Alignment”.

• Corrosion and/or cleanliness. Clean the electrodes with a soft dry

cloth or replace if necessary. See section “Replacement or

Alignment”.

• Correct alignment. Align the electrodes as shown.

Replacement or Alignment:

4.5.3 Loosen the screw (1).

4.5.4 Align the electrode as shown or remove if necessary.

4.5.5 Install a new electrode if necessary.

4.5.6 Tighten the screw (1).

4.5.7 Verify the electrodes are correctly aligned.

4.5.8 Reinstall the burner. See section Removing and Installing the Burner

Assembly.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 49 50

Sin comentarios

Wacker Neuson Cub 200 Manual del operador Pagina 32