Wacker Neuson Cub 200 Manual del operador descargar pdf (Pagina 17)

Cub 200/300/300 HD Operation

wcghi_tx000720gb.fm 17

3.4 Mounting the Handle and Base Assembly

See graphics: wcghi_003991 and ghi_gr005319

The Cub series Air Heater machines are shipped partially assembled.

Before operating either machine, use the following procedure to mount

the handles and base assembly. This assembly includes the handle,

base support, and wheels with axles.

Note: There are pre-drilled bolt holes for all the components installed

within this procedure.

Note: The Cub 300 HD requires that only the handle be attached.

Refer to the procedure below to install the handle.

3.4.1 Attach the axles to the sides of the fuel tank using the supplied bolts

and washers.

3.4.2 Install the wheels using a rubber mallet to secure them to the axle

ends.

3.4.3 Attach the base support to the rear of the fuel tank using the supplied

bolts and washers.

3.4.4 Attach the handle to the machine using the supplied bolts (and

washers, if applicable).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

Sin comentarios

Wacker Neuson Cub 200 Manual del operador Pagina 17