Wacker Neuson CRT 48-31V Manual del operador descargar pdf (Pagina 40)

Maintenance CRT 48

40 wc_tx000642gb.fm

5.13 Vanguard—Engine Oil and Filter

See Graphic: wc_gr000217, wc_gr003803

Change oil and oil filter (d) every 100 hours. On new machines,

change oil after first 50 hours of operation. Drain oil while engine is still

warm.

Note: In the interests of environmental protection, place a plastic sheet

and a container under the machine to collect any liquid which drains

off. Dispose of this liquid in accordance with environmental protection

legislation.

Drain oil while engine is still warm.

5.13.1 Remove oil fill cap (a) and drain plug (b) to drain oil.

5.13.2 Install drain plug and torque to 34.6 Nm (25.5 ft.lbs.).

5.13.3 Fill engine crankcase with recommended oil until the level is between

“L” and “F” on the dipstick (c). See Technical Data for oil quantity and

type.

5.13.4 Install oil fill cap.

5.13.5 To replace the oil filter (d), remove the installed oil filter after oil has

been drained. Apply a thin coat of oil to the rubber gasket of the

replacement oil filter. Screw the filter on until it just contacts the filter

adapter, then turn it an additional ½ turn. Refill with oil as described

above.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 75 76

Sin comentarios

Wacker Neuson CRT 48-31V Manual del operador Pagina 40