Wacker Neuson WL 30 Manual del operador Pagina 214

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 246
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 213
S E R V I C I N G A N D I N S P E C TI O N
212
Getting ready
1. Switch off all the loader‘s electrical controls.
2. Switch the starting key to position 0.
3.
Drive the vehicle with the good battery (charged battery)
near but not touching the loader.
4. Switch off all electrical controls on the vehicle with the
good battery and stop the engine.
Connect the jumper cables
Starting the engines
1.
Start the engine of the vehicle with the good battery and
let it run at an increased speed.
2. Attempt to start the loader engine.
3. If the engine does not start after 15 seconds, wait one
minute before trying again.
4.
Once the engine has started, let both engines continue
to idle with the jumper cables connected for about an-
other two minutes.
Detach the jumper cables
(The correct sequence must be adhered to)
1.
Connect the red jumper cable Item r (Fig. 99) to the
positive pole of the dead battery Item L.
2.
Connect the red jumper cable to the positive pole of the
charged battery Item V (Fig. 99).
3. Connect the black jumper cable Item s to the negative
pole of the charged battery.
4. Connect the black jumper cable to the negative pole of
the dead battery.
(As with connecting, follow the correct sequence):
1. Disconnect the black jumper cable rst from the nega-
tive pole of the dead battery and then from the negative
pole of the charged battery.
2. Disconnect the red jumper cable rst from the positive
pole of the charged battery and then from the positive
pole of the dead battery.
Vista de pagina 213
1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 245 246

Comentarios a estos manuales

Николай 26 Nov 2024 | 09:45:32

Назначение плавких предохранителей