Wacker Neuson WL 30 Manual del operador Pagina 182

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 246
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 181
S E R V I C I N G A N D I N S P E C TI O N
180
After the coolant has drained completely, ush the system
with clear water and making certain to capture the drained
liquid in a container.
1. Correctly reattach the lower radiator hose.
2.
Mix new coolant using equal parts of clean tap water
and new antifreeze.
3. Pour the new coolant into the radiator opening until the
radiator ns are covered with coolant. Do not add the
new coolant at a rate faster than 5 l/min (1.3 gpm) to
reduce the risk of air pockets in the cooling system.
4. Install the radiator cap.
5.
Check the coolant level once again after half an hour
of operation.
Changing the coolant
NOTICE
Replace the coolant after two years of use.
The coolant must consist of equal parts of water
and antifreeze. This mix guarantees an optimal ratio
of cooling performance and corrosion protection.
Do not exceed a rell rate of 5 l/min (1.3 gpm) to
reduce the potential for air entrapment during lling.
Use the capacity guide on page 155. Fill until the
coolant is below the neck of the radiator cap spout.
Replace the cap and run the engine briey.
Stop the engine and check the level. Add coolant if
the level has dropped.
1.
Stop the loader on a horizontal surface and set the park-
ing brake.
2.
Lower the loader lift arms and attachment to the ground
or the work surface..
3. Stop the engine.
4. Refer to Section 10.6, page 155 for the volume of cool-
ant and select a drain container of sufcient capacity
to avoid spillage.
5. Remove the radiator cap.
6.
Remove the lower radiator hose (remove the hose clamp
and remove the hose).
Vista de pagina 181
1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 245 246

Comentarios a estos manuales

Николай 26 Nov 2024 | 09:45:32

Назначение плавких предохранителей