Wacker Neuson CRT 48-31V Manual del operador descargar pdf (Pagina 32)

Maintenance CRT 48-31V-ES

wc_tx000144gb.fm 30

5.6 Drive Belt

0009482 Revs. 123 and higher See Graphic: wc_gr003665

0009216, 0009482 Revs. 122 and lower See Graphic: wc_gr000152

To replace the drive belt:

5.6.1 Place the trowel on a flat, level surface with the blades pitched flat.

5.6.2 Disconnect battery.

5.6.3 Remove the beltguard.

Honda / Kohler:

Remove bolts holding guard in place.

Vanguard:

Remove two bolts holding base of air cleaner to beltguard. Remove

two bolts holding beltguard to engine.

5.6.4 Remove 2 bolts (d), washers (e) and nuts (f) from each bearing flange.

5.6.5 Remove the 4 bolts (b) holding each inside universal joint to the shaft

fitting. Remove universal joints and shims (if included) from ends of

drive shaft.

5.6.6 Lift the drive pulley up far enough to slide belt past.

5.6.7 Remove the old belt and install a new one.

5.6.8 Reverse the procedure for assembly. Align the bearings and shaft as

straight as possible. Adjust pulley offset and center distance to values

as shown.

5.6.9 Torque the bearing bolts (d) to 99±10 ft.lbs. Torque the universal joint

bolts (b) to 10±1 ft.lbs.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

Sin comentarios

Wacker Neuson CRT 48-31V Manual del operador Pagina 32