Wacker Neuson Cub 200 Manual del operador descargar pdf (Pagina 43)

HI 110 / 200 / 300 Burner Setup

ghi_tx001449gb.fm 43

Adjusting fuel

pressure

8. Adjust the fuel pressure if necessary using the adjusting screw (e) and re-check

the settings. Repeat steps 4–6 to re-check the settings.

NOTICE: Do not adjust the fuel pressure to a setting outside the safe operational

parameters.

9. Remove the pressure gauge (d) from the pressure test port (c).

10.Re-install the threaded plug (b) into the pressure test port (c).

11.Re-connect the solenoid wire.

12.Close the access panel and re-install the two bolts (a) that secure the panel.

6.7 Setting the Air Band

Requirements

 Machine shut down

 Power disconnected

Procedure

Perform the procedure below to set the air band.

1. Shut down the machine and allow it to cool.

2. Disconnect the power cord from the power source.

3. Remove the access panel. See topic Removing the Access Panel.

4. Loosen the wing nut (a) and slide the air band (b) as needed. The front edge

should line up with the graduations (markings) on the flame head (c).

5. Tighten the wing nut.

Result

The air band has now been set.

ghi_gr00740

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Sin comentarios

Wacker Neuson Cub 200 Manual del operador Pagina 43