Wacker Neuson BH 24 Manual del operador descargar pdf (Pagina 34)

BH 23, 24

Removing tool

1. Swivel out handle on the tool holder.

2. Remove tool from the tool holder.

3. Press the handle on the tool holder.

9.4 Starting up

Work tips

 When working, use the weight of the hammers.

 Pressing forcefully against the material to be worked on does not improve the

machine's performance.

 Press the machine against the material to be worked as follows:

 Apply at least 100 N pressure.

 Press with sufficient strength that the machine noticeably locks into place.

 Apply somewhat less pressure as soon as you feel the lower stop.

Notes for operation below freezing point

The cold grease in the percussion system may increase the resistance to such

an extent that the centrifugal clutch slips.

f Allow the machine to warm up at low engine speed (do not press the gas han-

dle) to prevent the centrifugal clutch from premature wear.

CAUTION

Risk of burn injury from a hot tool and guide cylinder.

f Touch the tool only if you are wearing protective gloves.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Sin comentarios

Wacker Neuson BH 24 Manual del operador Pagina 34