Wacker Neuson GPSi 3200 Manual del operador descargar pdf (Pagina 35)

GPi 3200 / 4300 Operation

wc_tx001875gb.fm 35

3.17 Using AC Power

Prerequisites

 Verify that the engine is operating.

 Verify that the voltage displayed on the LCD (j) is approximately 120V.

 Turn off the equipment to be connected to the generator.

 Confirm that the equipment to be connected to the generator does not exceed

the maximum rated power output and specifed amperage.

Engine switch

position

Leave the engine switch (h) in the RUN position while the machine is operating.

Connecting

equipment

1. Insert the equipment plug into the 20A receptacle (b) or the 30A twist-lock

receptacle (c).

Note: To use the 30A twist-lock receptacle, insert the plug into the receptacle and

turn it clockwise to the LOCK position.

2. Turn on the power switch for the equipment.

Overload fault

Excessive current draw on the generator will cause an overload fault. When this

fault occurs, AC power is cut off and O_Lod displays on the LCD.

To clear an overload fault, stop the engine immediately and remedy the overload

condition. Then re-start the engine.

WARNING

Electric shock hazard. Failure to properly ground the generator could lead to

electrical sparks, especially if the connected electrical equipment is grounded.

f Make sure the generator is properly grounded. See Grounding the Generator.

wc_gr008631

AC 120V

NEUTRAL BONDED TO FRAME

RESET

TEST

OFF

TOTAL 2.8kVA

NEUTRE MIS A LA MASSE

A LA CARCASSE DU MOTEUR

GFCI AC BREAKER

DC BREAKER

OPEN

CHOKE

DC12V-8.3A

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

Sin comentarios

Wacker Neuson GPSi 3200 Manual del operador Pagina 35